Package specification: 10000w governor
Product information
Model and specification: acmc100-1
Service voltage: AC 220V
Maximum power: 10000w ultimate power of resistive load. It is recommended to use within 5000W at room temperature for a long time
Voltage regulation:
about 20 from 0-200v
Rated current:
25A
Maximum current:
45A
Maximum power: 10000w (at 220V)
Product size: 130 * 60 * 47mm (length * width * height)
PRODUCT INSTRUCTIONS
Wiring indication
Note: the load must be connected before voltage regulation
Product features
Using the new bidirectional high-power thyristor, the current limit can reach 100 a, which solves the overcurrent problem caused by too small resistance of electric furnace wire when it is cooled; It is very convenient to adjust the output voltage of mains power, which can be adjusted arbitrarily between 0-220V for electrical appliances. Such as: heat regulation of electric furnace and water heater, light regulation of lamps, speed regulation of small motor, temperature regulation of electric soldering iron, etc. So as to adjust the light, temperature and voltage. It can be used for large electrical appliances with power less than 10000 watts. Because the power is already large, it is enough for general household appliances or small factories. (the inductive or capacitive load power should be reduced. The voltage regulator is
equipped with bidirectional high-power thyristor, which can be used without adding any components. It is very convenient and practical
Product features
1.
This product is AC input and AC output. It can only be depressurized and regulated when connected to load. It's useless to connectto multimeter without load. It's not a transformer. Please read all the instructions on the product page before buying!
2. It is suitable for enterprises that need to use low-voltage adjustable foam cutting technology, such as low-voltage adjustable hair dryer, which is more suitable for enterprises that need to use low-voltage adjustable foam cutting technology.
3. This product cannot replace the battery charger of electric vehicles, nor can it drive the electrical appliances using switching power supply (such as 110V TV, stereo, refrigerator and air conditioner. Electric cooker with computer) nor can it drive induction cooker and energy-saving lamp.
4. Thyristors are mainly used for resistive loads (electric heating wires, incandescent lamps, etc.) Most single-phase AC motors are OK, but there is no guarantee that they are OK. Other types of loads should be confirmed by the buyer. The fuse has a reaction time. If the current is too large, in addition to burning the fuse, the module may also be burned out.
Product materials
1. The military grade double-layer circuit board design is adopted at all costs, which is by no means other home
Single layer board comparable
2. Thyristor with original imported chip and special customization
3. All high voltage capacitors
4. All metal film resistors
5. St original imported trigger diode comes with heat sink, which can be used by buyers when they get it
matters needing attention
1. The output voltage measured at no-load is the same as the input voltage, and the output voltage can be measured only when a load of more than 20W is connected
2. Input AC, the output is also AC, not DC.
3. The 4000W mentioned above refers to the power when working under resistive load, the inductive load is 1 / 3 of the resistive load, the resistive load refers to electric lamp, heating wire, etc., and the inductive load refers to series excited motor, etc
4. Electrical appliances with metal shell should be grounded safely.
